Three polymers decide the majority of flexible barrier specifications: EVOH, PVDC and PA (nylon). Each wins on something, each loses on something else, and the choice is rarely technical — it is regulatory, supply-chain and end-market driven.
EVOH
The barrier champion and the default choice for oxygen-sensitive food. Excellent aroma barrier, flexibility and print compatibility. The trade-offs are moisture sensitivity, a higher price per kilo, and supply concentrated among a small number of resin producers.
PVDC
Still the strongest overall barrier for fat and odour, and it performs very well in shrink film. The regulatory direction is clearly against it: several markets restrict or phase out PVDC in food contact, and recyclability claims are hard to sustain with a chlorine-containing polymer. Long-term, this is the material most likely to be removed from your specification.
PA (nylon)
PA is a structural and aroma barrier rather than an oxygen barrier. It brings outstanding puncture and tear resistance, deep-draw thermoformability and print surface quality. Almost every meat pack is PA-based — but PA alone will not hold oxygen, which is why the industry's answer is to bond PA to an EVOH core.
The decision matrix
| Factor | EVOH | PVDC | PA | PET |
|---|---|---|---|---|
| Oxygen barrier | Excellent | Excellent | Moderate | Moderate |
| Moisture barrier | Good | Excellent | Excellent | Good |
| Aroma barrier | Excellent | Excellent | Excellent | Moderate |
| Retort 121 °C | Good | Good | Excellent | Good |
| Recyclability | Good (mono) | Poor | Difficult | Good |
What we recommend
- Fresh protein and dairy — PA/EVOH/PE. Structural strength from PA, barrier from EVOH.
- Shrink film where odour control is critical — EVOH-based if your market allows it, PVDC only where regulation permits.
- Any application with a recyclability commitment — mono-material PE/EVOH/PE.
- Deep-draw thermoforming where EVOH is a barrier on the outside of the draw — PA-based with the EVOH core placed away from the draw.
There is no universal winner. The correct question is not "which polymer is best" but "which failure mode is costing me money, and what does my market permit".