This is the most common misconception in barrier film specification, and it leads to real failures.
EVOH is an oxygen barrier, not a water barrier
EVOH blocks oxygen extremely well and water vapour only moderately. The polar hydroxyl groups in the polymer that give it outstanding oxygen barrier performance also make it hygroscopic — it absorbs water rather than blocking it.
So what does this mean for your structure?
EVOH must always sit between two moisture barriers. PA is excellent on moisture and moderate on oxygen; PE is excellent on moisture and poor on oxygen. A typical structure uses PA outside for strength and moisture, EVOH in the middle for oxygen, PE inside for sealing and moisture. Every layer does a different job and none of them can be removed.
Which failure are you actually protecting against?
- Oxidation — beef greying, fat rancidity, aroma loss, vitamin degradation. EVOH core, high priority.
- Moisture gain — dried-out product, crispness loss, sogginess. Moisture barrier layers, gauge control.
- Moisture loss — weight loss, texture change. Moisture barrier layers, WVTR spec.
- Aroma transfer — odour migration between SKUs. EVOH core.
The practical consequence
If you only need an oxygen barrier and your product is not moisture-sensitive, a structure with a higher WVTR may still be fine — and cheaper. Conversely, if you need serious moisture control, adding EVOH does not solve it and may make the structure more expensive without helping. Specify the failure, not the material.